im about to pull my engine to do a rebuild. can anyone suggest where to attach the engine hoist?
never done it before but i think you attach that sliding balance thing that has four chains hainging down right?
and those four bolts hook up somewhere
i was thinking the intake manifold and exhaust headers?

thanks guys.


z24 - CAI - Magnaflow Cat - PaceSetters
--exhaust and unorthadox pulley soon

there are pulling anchors on the the left front and the right rear of the engine (2.4)

left side is near the engine mount, there is a circular part down by the alternator. this piece is pretty beefy and will not be hard to miss.

right side is a little steel ring attached to the exhaust cam tower. (the fuel lines run right by it)



Wanting a nice set of black 17's with mint tires? Pm me.

z yaaaa wrote:there are pulling anchors on the the left front and the right rear of the engine (2.4)

left side is near the engine mount, there is a circular part down by the alternator. this piece is pretty beefy and will not be hard to miss.

right side is a little steel ring attached to the exhaust cam tower. (the fuel lines run right by it)

thanks this sould help alot.


z24 - CAI - Magnaflow Cat - PaceSetters
--exhaust and unorthadox pulley soon

lol @ intake manifold @!#$ would snap that in a second

Jonathan shumacker wrote:lol @ intake manifold @!#$ would snap that in a second

yea didnt really think that one through too much


z24 - CAI - Magnaflow Cat - PaceSetters
--exhaust and unorthadox pulley soon