Any advice is appreciated. I don't have the money to lower my car properly other than cheap eBay springs on stock struts. I don't want to do that. Is there another way?
Larger tires....but the front spring perches will become a problem if you do not space our the front wheels a little. If you do run spacers longer wheel studs are probably needed.
The rear should clear fine, but I would space them out to match the front.
PRND321 Till I DIE
Old Motor: 160whp & 152ft/lbs, 1/4 Mile 15.4 @88.2
M45 + LD9 + 4T40-E, GO GO GO
My front wheels already stick out about a cm from the fender lol. I'm running 245/45/17. I might just wait to lower.
Stick a couple fat chicks inside. That should lower it nicely.
I have a set of Eibach pro kit springs for sale. $150 shipped for 1 year old springs an $75 shipped for a older set with a small piece broke off the tip (can file a claim thru Eibach for a new set) pm me if your interested.
Pm to show the chip.
The fat girls method doesn't work for me, but I guess if that works for you then you can have hydraulics if you tell them to jump around.
NO ,JUST WORK HARD ,PULL DOUBLE SHIFTS OR GET A SECOND JOB LIKE I DID .BE PATIENT, SAVE UP SOME CASH AND THEN GO OUT AND BUY SOME GOOD PARTS AND DO IT RIGHT THE FIRST TIME.TRUST ME YOU WONT REGRET IT!
BLACKMANTIS
