I switched to a Z24 front after my BC front was taken out by a tire shred.

So now I'm going to swap my Drift sides for stock sides(probably 95-99 Z24) but I don't know if it'll line up with my BC rear or if I should put my stock rear back on as well to complete the kit.

I'm thinking my BC rear will be lower but my Drift sides are a little lower than my BC rear so that got me thinking stock sides will be close to lining up

I know my BC rear was super low. I don;t see how stock sides would come even close to lining up.

Give it a try and see

You're right, couldn't hurt just to see since I can easily swap to stock if it doesn't come close to lining up.

But looking at it closer today, it is pretty low lol

worst case, just throw in one bolt in each end just for a quick look. Shouldn't take more than a few minutes to do.

True, only thing is I have my exhaust tip lined up for my BC rear but it'd be under my stock rear anyway so I guess that doesn't matter too much

J03Y wrote:I know my BC rear was super low. I don;t see how stock sides would come even close to lining up.

so was mine. i cant imagine theyll be close enough at all, esp w z sides since they were pretty skinny to begin with

I could see it possibly working with 02+LSS sides or maybe vert sides? But I'm doubting the Z sides would fit.