I got the kit with front/rear bumper and side skirts.
Is there a door striker piece that goes between the side skirts?
<img src="http://www.majhost.com/gallery/HCAJosh/crap/shooshined.jpg">
- putting the pieces back together -
there used to be but they stopped producing it years ago if i remember correct.
they're damn near impossible to come across these days.
what joey said best bet get creative and make ur own. if u do the kit right it doesnt look bad with out them anyway.
the fender part of the skirts dont bother me, its the quarter panel part that looks out of place.
Any know how close in size the drift skirt is in comparison to a 03+ quarter panel side molding?
I think it would flow with the drift skirt if you used turned the molding the opposite direction.
Option 2 was cutting off the part that raises up on the fender, where the "pit" is formed.
The skirt would flow with alot more front bumpers(hell I dont think the drift front bumper flows with the drift body kit).
<img src="http://www.majhost.com/gallery/HCAJosh/crap/shooshined.jpg">
- putting the pieces back together -
You could always cut the quarter panel portion off flush...
Every once and a while you can find the door caps on ebay...not often, but I've seen a few
i used the door mouldings from an 03...think it looks pretty good see sig
Alysha Kotlan wrote:i used the door mouldings from an 03...think it looks pretty good see sig
is that a sunfire molding that goes all the way across the door?
<img src="http://www.majhost.com/gallery/HCAJosh/crap/shooshined.jpg">
- putting the pieces back together -
Cruisin4DrCav wrote:You could always cut the quarter panel portion off flush...
Anyone ever cut the fender portion off flush on a 2door?
<img src="http://www.majhost.com/gallery/HCAJosh/crap/shooshined.jpg">
- putting the pieces back together -
no its off a cav and it doesn't go all the way...prob an inch or 2 on each side
^maybe u should post the ACTUAL picture!
WiGM-Tuners member.
Evan the Undead (Black Pearl) wrote:you could get the Sunfire doors with the pieces already there and not worry about molding...
Or.. take the molding off of the door and put the molding on your door.
A whole lot lighter then swapping whole doors.
<img src="http://www.majhost.com/gallery/HCAJosh/crap/shooshined.jpg">
- putting the pieces back together -
This is an old picture, and the car is dirty...
if you're gonna do anything, do it right. either cut the QP portion off, or mold it to the quarter.
don't mess around with hackjob @!#$, like mismatching door strikes.
Check out my build thread!
the strikes/moldings wouldnt be mismatched
and swapping the lower door moldings would mean drilling holes.. or at least the Sunfire doors I had ('o3+) had the lower pieces clipped to the doors, not double-sided taped
R.I.P. JessE Gerard 7.11.87 - 1.25.08
The Radiation Nation Facebook Twitter Twisted Metal Alliance
Sunfire door strikers FTW on drift side skirts. Only way to go.
Anybody have a picture of the Sunfire strikes with the drift/blitz skirts?
