well, im puting in my air ride over the winter, and i was planning on moulding in my kit(and no its not a DD). I then thought about when you lay the car out, i'd probably crack a little bit everytime I lay out. Does anyone have a moulded kit with air?? im guessing few if any.

what do you guys think? will i kill the moulding when i lay the car out? anyone ever do it?? thanks in advance./





Fred Ohlson "The people that devised this cruel attempt
at acceptance and fame burn in there honda civics"

it wont crack it. you can lay it out and be fine. make sure you roll the fenders so you can tuck and then when you lower it, just know what psi it will sit at before it touches the ground. my drift kit use to touch the ground with about 10-15 pis left in the bags. now my trd kit i can let the air completely out of the bags and its about 1/2" from the ground

I've never had any problems and my whole kit is molded as well. Then again, I have a smaller kit on my car so it doesnt actually lay on the ground, well, at least not until now it didnt.

awesome. thanks for the input guys





Fred Ohlson "The people that devised this cruel attempt
at acceptance and fame burn in there honda civics"