Ok here is the thing, I have a 2003 ecotec intake manifold and I just baught a new msd
map sensor and I don't know how to go about making this thing hook up into my intake
manifold. If anyone has pictures or ideas let me know so I can get my project done and
get it out on the roads.

Thank you for any help in advance.

The part is the MSD-2313 map sensor. Also how do I wire it up correctly???


Project Yellow Blur Is Under Way ! ! ! ! !

HELLO I NEED SOME HELP!!! I cant figure out how this will fit into the stock stop
cuz it wont and I dont know what to do.


Project Yellow Blur Is Under Way ! ! ! ! !

I cant figure out how this will fit into the stock SPOT
cuz it wont and I dont know what to do.


Project Yellow Blur Is Under Way ! ! ! ! !

are you running this as a second map for an EMS or are you running this to your computer?

The msd should be plug and play as far as wiring goes. as far as mounting it to the intake, I have seen people put the nipples in the stock hole, and running hose to a remote mounting location for that.

Ya i am adding this so I can tune a 3 bar setup with hp tuners


Project Yellow Blur Is Under Way ! ! ! ! !

So I am guessing that is really the only way to do this is to
nipple it and run a hose to a different location.


Project Yellow Blur Is Under Way ! ! ! ! !