sup guys...well i posted last year my first time at the track..well i went back..
i have a 2001 2.4 L with intake, header exhaust (2.25" piping), poly urathane motor/tranny mounts and short shifter sitting on 18x8 konig unknowns with a 225/40 series tire and the tire pressure was between 40-45 psi...
my new time was:
reaction: 0.019
60': 2.3
1/8 Mile: 10.03 at 70.5 mph
tell me what yall think.. lata
not bad
Im a Xbox 360 fanboy...and damn proud of it!!
pretty good
Dark for fear of failure
An inner gloom as wide as an eye and fermenting
Roiling hate
Death gripped my veins
Unveiling rancid petals
Flowering forth foul nectar
The space between a blink and a tear
Death blooms.-mudvayne
The times aren't shabby but there's definite room for improvement
60' time is ok, but like i said can be better. if you can get out of the hole better, you're 1/8 will drop considerably.
I ran a few 10.0x's when my car had a 2200 OHV in it.. I've since swapped to an ecotec and have run 9.5s at 73mph.. my 60 ft was a 2.16
if you can get off the line better, u should see improvement altho your 18s could be hurting your top end (as reflected by your trap speed)
Lose the 18's and it'll pick up.
Semper Fi SAINT. May you rest in peace.
throw some steelies on and lower the pressure then youll see whats up.
well thanks guys for your responses...i want to try and get a hold of some 17x8 Motegi Track Lights with some decent tires for my track wheel and keep my Konigs for Street..what do yall think?
17s are still too big lol
i have 15s with Drag Radials if your going to the track with other rims get real track tires : ) my car is basically stock and by best 1/8th mile is 9.76@71
really? what mods do you have? but i also have a really low front bumper (drift)..sayen would 15's with semi slicks be to low?
I have
Poly engine mounts(Mark Pain)
Poly Tranny mounts (prothane)
poly Control arm bushings (prothane)
Warm Air Intake (Cosmo Racing)
NGK Iradium Spark Plugs
Centerforce Dual Friction Clutch
B&M Short Throw Shifter
225/50/16 BFGoodrich Comp TA drag radials
if i were you i would get the 215/60/14 they are pretty close to stock height mine are 1.5 inches shorter/ my best 1/4 time now is 15.116@90.95
sounds good...I have a 2.4L with AEM Intake, PaceSetter 4-1 Header, 2.25 " Piping with magnaflow High flo cat, magnaflow resonater, and magnaflow muffler, polyurathane engine and tranny mounts (thanks to Karo), B&M Short throw Shifter...with slicks..im hopen for 9.32-9-5s..
