I've never really seen a "How To" post on this, so I thought I'd put up some pics. I'd also like to thank Nity9CavSedanCRJ (Cody) for assisting in the "surgery." If it's a repost, I'm sorry. Enjoy








^^^ When you're drilling, make sure you watch out for the wiring harness and hood release cable--they're RIGHT underneath the tray.



Most people could probably stop at this point, but because I need to fit (2) 2.5" tubes through this section, I wanted it to be a little bigger.





This is where I left it (for now.) The reason it looks so rough is that I'm going to make a plate out of stainless to sit on top of that entire area. Once it's cut to size and the edges are cleaned up, I'm going to put (2) 3" tubes in the center of it and trace around them(probably looking like a figure 8.) Cut the wholes out, polish the plate to look like our intakes, and DONE

Questions/comments welcome!

SWEET so when i do my tboost on my sunfore i know how to pull the tray. and agent i love the car.

First off - great post.

2nd off... you're gonna run a few pipes through there, correct? For charge piping?

-Chris-



-Sweetness-
-Turbocharged-
Slowly but surely may some day win this race...