the abs light stays on all the time. I know i could easily take the bulb out but I want to find out the problem that it is staying on there has to be a problem for it to stay on (some one help)

get the code read at the dealer.....most likely a bad wheel speed sensor, may need to replace a bearing.

I have that problem I changed the wheel sensor that was bad put a scannr on it to erase the code and it wont go away but the scanner says everything is fine and my abs works


z28guy(KGM BEOTCH)

BTW getting it scanned is not free like a check engine light code that oyu can get scanned at autozone for free.


98z24, lowered 2", aem intake, cat-back striaght pipes!, cop ligths in the front and rear, 18" liquid metal's, primer black, tint, full audio and video.

As others have said, you need to get the code. In my case, the ABS pump was bad which forced both the Brake and ABS lights to stay on. The brakes appeared to work normally, but the ABS was obviously not on. It was a (VERY) expensive repair at a dealer (my last BIG mistake). - Mark

if the abs light is on, your ABS will not work. If your abs is working, and the light is on......sounds like you have some funky wiring issue perhaps.

i had a bad abs motor the thing with all the plugs,brake lines and master attached to it i had the dealer scan my car to find that out but i went to the junk yard and got the part changed it bled the lines at the abs motor and everything isfine now you can hook up an ohms meter to the wheel speed sensor and spin the tire when its on a lift to find out if its bad if you dont get anything out of it then its bad!!! just from prior experience.