i just have a quick question for those with the samurai or ronin style seats.
i plan on using a 4 or 5 point harness so i need to know how high the cut out for the belts is from the bottom of the seat. i dont want the belt to go over my shoulders and then down through the cut out in the seat and back up to the harness bar.
so... if anyone could measure their seats from seat cushion to the top of the belt cut out that would be great

_





Now with northstar V8, IRS, 20's n 22's

For one, if you need a measurement, sit down and measure from the floor to your neck - most likely it's gonna be pretty close to the measurement on the seat.
Next, what are you saying?? Are you saying that you don't want the belts to go thru the holes, sag down, and then go back up to the harness bar??
If so, just get wrap around harnesses - you can basically make them any length you need.

-Seth

i can figure out the height i want them to be but i need the actual measurements off the seats. i dont want the harness to go around the seat i want them to go through, bear in mind it is mostly a show car with some cruise time and a bit of drag strip time. it may seem overly picky to some but i want the belts to go through the seat.
i want the belt to go up from my shoulder to the harness bar not drop down as it goes through the seat. if i cant get a hold of measurements i will have to try my luck going by pictures of the seats.
thanks for any help

_





Now with northstar V8, IRS, 20's n 22's

O, ok, I think I get what you're saying now.

-Seth