Anyone p＝have install pictures of a 3rd gen bifold 60/40 seat in a pre 2002.
On the inside my car looks like a fighter jet.
Anyone have install pictures of a 3rd gen bifold 60/40 seat in a pre 2002?
On the inside my car looks like a fighter jet.
i dont see the point of the pics? as it would look exactly the same as those years
but I want to see the install pictures. I have a 2000. The rear seat doesn't bolt in and has 1 center latch. In 2002-05 it bolts in and has 2 latches.I have pictures of how it was installed but I wanted to see if anything needed modifying or if there is an easy way to do it. I just figured if someone had tips then it would limit my trial and error. It is not really a big deal.
On the inside my car looks like a fighter jet.
Anyone? I'm doing this tomorrow.
On the inside my car looks like a fighter jet.
i know at the very least the rear deck cover needs to be clearanced to fit the two latches
so far as how they're attached, you'll have to figure it out.
do you have the cables and the pull straps for the release? you know they're in the trunk right?
Yes I have both the cables, brackets, and release straps.
On the inside my car looks like a fighter jet.
ive been wanting to do this for awhile now as well. i still need the folding section of the backseat as well as the latches. so far as i can tell all you need to do is make the stock 03-05 latches fit into the body. im sure its a pretty straight forward install, honestly. gm didnt change much with the body. hell there might already be the openings there to put the latches into, never know.
M45/OS crank/2.4 snout. It's nice to be injected but I love being blown!
i did this in on emy old cavaliers. i didnt mess with latch however, they fit tight enought they didnt fall down. I just lag bolted the seat hinge to the floor and went.
nah this is where the hump right befire the trunk floor begines.
No gas tank to worry about. I'm going to install the seat tomorrow. Haven't had any time it's been sitting on my bench at my shop for a month or so now.
On the inside my car looks like a fighter jet.
Got the seat installed and works great. Had to cut off the 3inch peg on the passenger side where the old seat mounted on. Drilled the 4 holes and mounted the latches. I'm going to make the release cables accessible from the cabin so I need to pick up another smaller cable from the junkyard since the factory uses one small and one long and mounts them in the trunk.
On the inside my car looks like a fighter jet.
