I think I remember reading that rota wheels would not fit our hubs and that they needed to be bored out. Can anyone confirm or deny this?? thanks
Will
best bet is to look on rotas site. they should fit. i believe the bore size is bigger than 57.1mm. if so then all you have to do is get hub rings
no there smaller. your going to have to get the bored out but not very much. i cant remember the exact size
http://www.gadomestics.com/
not all of the models are like this, you can look up the hub bore size on rotas website but like stated above the hub size should be 57.1mm. good luck and post pics when you get them.
I know my 18 inch rota subzeros needed like a 5mm bore out in the hub very easy... dremel em is a good idea... or use a
Pipe Deburring tool... I used this
LE61T PTE6262 Powered 
Have them machined at a machine shop. Saving a little money is not worth risking your life.
- 93 mph in the 1/8 mile
Member of J-Body Of Michigan.
