I order a new clutch kit and I removed my transmission, now there are some things I'm not too sure about.
My bad if these questions have been asked before but I couldn't really find much considering I don't know much.
I added pictures to make sure everyone understood what I was asking.

My clutch kit comes in tomorrow so I'd appreciate any help.

1)I'm not sure what this small line(hose) is for and where it is suppose to go. Does it go to the master cylinder?


2 & 3) Only one of these were connected to the master cyclinder line, what might the other one be for? And am I suppose to grease the inside(back) of the slave cylinder or any part of the slave?


4) One last small question. Is the pin that holds the slave in place suppose to have anything else on it or does the slave just slide right on like that?

Funny I was going to make the same post.

Btw, your pics are not working











~2014 New Z under the knife, same heart different body~
______________________
WHITECAVY no more
2012 numbers - 4SPD AUTOMATIC!!
328 HP
306 TQ