Hey guys, I have a few questions about the B&M Shift Plus Shift kit. Is it just a line pressure solenoid you replace in the valve body or do you replace the valve body as a whole like I have done in the past with RWD vehicles. Also, for those of you who are using it, how do you like it? And finally, where can I find it? I have an 03 Eco with an M62 Supercharger pushing 13-15 PSI. Its time to toughen the ol' 4t40 up! Thanks guys!
It is an electronic box that connects into wires... All electrical...
We have them at www.TurboTechRacing.com
-Aaron
www.TurboTechRacing.com
Performance Parts For Cavalier, Sunfire, Cobalts and More!!!
I used it,worked pretty good,easy install
15.2@89mph 2.171 60ft. 9.830 1/8 R.I.P. "LULU"
it is amazing had no problems nice hard shifts to gives 3rd gear a lil more so its good
8 psi with m62 and IAT under 100
Easy install.. its like hardest part is to find the right red wire w/ black and light blue wire w/ white... and i was so skeptical about doing it until one day i was so bored i just installed it.. i ran a 16.0 before i installed it.. after i ran a 15.8 in the 1/4 mile.. so totally worth it.
SS-J wrote:Easy install.. its like hardest part is to find the right red wire w/ black and light blue wire w/ white... and i was so skeptical about doing it until one day i was so bored i just installed it.. i ran a 16.0 before i installed it.. after i ran a 15.8 in the 1/4 mile.. so totally worth it.
Nice results, good bang for the buck I'd say.
Milt Burns, milt@neverenoughauto.com 877-609-6727
