On one of my look throughs I noticed I was missing the bolt for the rear mount. I found where it fell out at and tried to reinstall it, to my dismay I found the tranny is just a little too heavy to lift with a bolt and a wrench. Now to my question, where is the best place to place a jack in order to lift the tranny enough to get that bolt in with out damaging anything. Oh yea FYI it is a 95 cavy 2.2 5spd. Any opinions would be greatly appreciated


<img src=http://donut.parodius.com/agtp/images/GonMad.gif>
What makes you think I'm crazy?

Place a wide piece of board on the bottom of the oil pan and Jack it up. That would be the easiest way without having to worry about the jack slipping.


____________________________________________________________________

Madjack wrote:Like I said before, building an engine like ours (2.2 or 2200) is a painstaking chore , since there is so few custom made parts. It's frustrating to me too, but that's what I like about doing this engine, it's the challenge.