well here you go this thing is 26-10-3" i hade to cut off the hood latch suports and remove the ac condenser just to fit it so it would be hard to notice the one pic i am at an angle so you can see the end tank kinda
r.i.p rotary
nice, can't really see it with the bumper on. knocks up the sleeper effect.
View my MySpace
thats how mine is, fits perfectly within that grill but you can't reall tell visually lol
LE61T PTE6262 Powered 
i am monting the turbo over the tranny so that should be fun.. its the only way i can fit the turbo in there! damn 60-1
r.i.p rotary
hiding it is cool, but how much airflow is it going to get mounted like that?
are you cutting out the grille in the center? That'd work just fine.
as much as it would it would monted right in front.. its just a little further back.. yours will fit? what manifold are you using? maybe a link or is it homemade?
r.i.p rotary
okay nm exploited.. well hmm? i will see what it takes to mount over tranny and judge what will be best.
r.i.p rotary
Heres mine i think its overkill but future plans
Try to ignore the ugly mugs in the photos it was late. eric my friend is in teh first and im on the bottom one.
*2012 mazdaspeed3*
stevefire wrote:hiding it is cool, but how much airflow is it going to get mounted like that?
are you cutting out the grille in the center? That'd work just fine.
it'll be fine there
I was a retard, and now I'm permanently banned.
my bumber is alot thicker than yours your lucky
r.i.p rotary
It was modified to fit it in that location but for the fact that its half covered i am going to install c02 custom made co2 sprayers in the bumper where they are cut. Im gonna have a fairly large commercial co2 tank in the trunk so im gonna have c02 sprayers basically on most of the charge pipes but we will see where this winter leads me.
*2012 mazdaspeed3*
yeah i am tight on cash for a month damn x-mass it should be called x-mess.. o your eco cool.. well my goal is 300 or close with under 10psi, and i don't want it to be obviouse either. but i got looking under my hood and my abs is right were i would need to run the dp if i was to remote mount it. so looks like exploited here i come..
r.i.p rotary
what do you mean dp like downpipe or what? And what are you getting from exploited racing?
*2012 mazdaspeed3*
yeah down pipe and exploited racing
manifold
r.i.p rotary
yeah xmas is a drain on the funds but if your in college their is the excuse of you being poor so no one expects much. I try to route my funds into my car its kinda sad. But its what i love and i dont think it will stop. My bro on the other hand is always very generous to me so i just ordered my spec stage 2 with his credit card last night so i was really excited about that. Good luck with your downpipe and what not. Why not see if you can get a manifold through hahn? or is it for a 2200.
*2012 mazdaspeed3*
its the 01 z i didn't think hahn made stuff for the 2.4?
r.i.p rotary
They dont wasnt sure what year you had and i didnt bother tocheck the prof.
*2012 mazdaspeed3*
