Innovate, stand alone WIdeband Problems?????/ - Boost Forum

Forum Post / Reply
You must log in before you can post or reply to messages.
Innovate, stand alone WIdeband Problems?????/
Sunday, May 15, 2005 10:38 PM
hey guys, i installed my wideband the other day and all i get on the gauge is - - - and i looked in the manual and it says check cables, cause sumtin isnt hooked up rite, K well the gauge is grounded n powered proporly , and the main adapter is powered and grounded properly 2, cause when i hook the wideband sensor into the connecter it starts 2 heat up ect...SO i am wondering what it would be, I attached my computer 2 the out conector of the gauge and the block off from the sensor, and i can adjust the gauge fine so thats ok.....but i duno soon as i start the car it goes to - - - i cant initiate a free air calibration or anything im STUMPED man, i have no idea what 2 do... would anything with the output wire have anything 2 do with it?...or the output ground?.... i duno wat 2 do anyone???

<a href="www.daptronics.com">www.daptronics.com Huge Discounts on Electronics</a>

Re: Innovate, stand alone WIdeband Problems?????/
Monday, May 16, 2005 12:55 PM
this is for the single gauge correct ??

you might want to talk to karo if you purchased it from him , or who ever you purchased it through , or talk to inovate themselves


i know my hand held it was easy to to , and i havent installed my stand alone gauge yet , but looking over things , it should be very hard to do


only think i can think of is maybe the unit is DOA







Re: Innovate, stand alone WIdeband Problems?????/
Monday, May 16, 2005 8:43 PM
Hm ya its the stand alone kit , i havent had time 2 mess with the analog output but its connected to the emanage, and the ground (which says 2 be linked 2 the ground of the emanage) is just grounded normaly, i doubt that would affect it but i mite jus try unhooking the analog out.... i have no idea what could be wrong, considering the sensor heats up and everything

<a href="www.daptronics.com">www.daptronics.com Huge Discounts on Electronics</a>
Re: Innovate, stand alone WIdeband Problems?????/
Monday, May 16, 2005 9:00 PM
yeah try just having the wide band hoked up to it self first







Re: Innovate, stand alone WIdeband Problems?????/
Tuesday, May 17, 2005 7:19 PM
HEy guys i fixed the problem...THe one adapter that goes into the cords 2 block a signal has 2 be in the input of the lc1, BAH

But NOWWW i let the sensor heat up, and it counts down, starts 2 calibrate, and then it gives me error 8, which means overheating sensor, or bad sensor..and its brand new, i cant believe it im sooo mad ugh ....any other ideaz?

<a href="www.daptronics.com">www.daptronics.com Huge Discounts on Electronics</a>
Forum Post / Reply
You must log in before you can post or reply to messages.

 

Start New Topic Advanced Search