Has anyone who installed a GM blower kit had to replace the PCV baffle cover gasket?
The instructions say to reuse the stock one but to replace it if it's damaged or worn out.
It's going to cost me $30 CAD for a new one so I'd rather not pick it up if I'm not going to need it. I certainly don't want the lack of one to delay the installation though.
Since they have to order it, apparently I can't return it if I end up not needing it.
Has anyone at all needed a new one or does the old one transfer over just fine?
Is it something that's worth replacing as a maintenance item?
No problems with mine
"Life Is To Short To Dance With Ugly Women."
it should be the O-ring style like the TB gasket is , and the ports on the s/c are
so it should be fine
It's a rubber gasket. Mine was just fine.
Dude, just install the thing already! You're asking too many questions. That takes the fun out of it
<a href="http://www.j-body.org/members/mrpute"><img src="http://www.j-bom.com/images/sigs/putesig.jpg">
hehe. Just trying to address everything before it goes in. Install will start at 9 sharp Saturday morning.
Still got almost half a tank of 87 to burn through between now and then...
mine was fine.. it stuck to the block actually, there's nothing holding it there.. just lifts right off
14.82 @ 97 mph
