Ok, these are the last 3 bends I need for my intercooler pipes.. Everyone seems to be out, or on back order.. Nobody close in my home town do these kinds of bends. Soo im asking you guys if you have a website or know a place where I can get these bends.
What I need.
Quant (1) - 3" 180 degree bend in stainless steel.
Quant (2) - 2.5" 180 degree bend in aluminum.
I obviously checked the place that did the rest of my piping lol.. I checked jegs, their on back order, and I checked summit and I didnt even see these bends listed on their site.. Maybe I missed it?
But if someone could help me out that would be great..
Thanks.
~2014 New Z under the knife, same heart different body~
______________________
WHITECAVY no more
2012 numbers - 4SPD AUTOMATIC!!
328 HP
306 TQ
Search ebay, the best prices i've seen on aluminum piping have been on ebay.
- 93 mph in the 1/8 mile
Member of J-Body Of Michigan.
Duhhh, damn I didnt even think there lol.. Thanks man..
btw, I did find a place where I just bought the 2.5" 180 degree bend in aluminum. Now I need to search for the 3" SS one..
~2014 New Z under the knife, same heart different body~
______________________
WHITECAVY no more
2012 numbers - 4SPD AUTOMATIC!!
328 HP
306 TQ
this may seem like a stupid question but isnt 180 degrees a straight line?
My car may run 18s, but I can do your taxes in 10 seconds flat.
JBO lube - they would never have enough in stock and we'd never see RodimusPrime again
Technically yes, but when you get a 180 degree bend you need that bend bend in the middle.. Just like the letter U.
I found that 3 incher I was looking for on ebay, now Im done.
~2014 New Z under the knife, same heart different body~
______________________
WHITECAVY no more
2012 numbers - 4SPD
AUTOMATIC!!
328 HP
306 TQ
Or if anyone actually uses the search button and this pops up, vibrantperformance is always good.
STREET ANTIX, it's coming...
