It can be used to take the pulley off and put the new one on right? Also if so, how do you go about putting the new one on?
Thank you!
if they did it like the 2.4L s/c'er kits you will only be able to pull it off with the puller.. check the end of your S/C'er... is there a threaded hole? if so then yes you can use it to put the new hub on
The First Twin Charged jbody
blue car (R.I.P) - 240whp @7psi..
silver car - 305whp 315lbs.tq @15psi (91 Octane) or 420whp & 425lbs.TQ @20psi (94 octane+Alcohol Injection)
All dynos run on a Mustang dyno
I have the pulley boys puller and used it to remove and install the pulley on the M62 for the Eco, worked well...
12.770 @ 111.99 Intercooled Eaton M62
