Wireing a sub for out of car use - Audio & Electronics Forum - j-body.org

Wireing a sub for out of car use - Audio & Electronics Forum

Forum Post / Reply
You must log in before you can post or reply to messages.

Wireing a sub for out of car use

Saturday, January 05, 2008 6:13 PM

Is it possible to wire a car sub (In this case a 10" Kenwood), for a in home use? It needs 100-175w RMS @ 4Ohm. Is there a single sub amp for in home use that would push that fairly low power rating? I know that it will probably sound like garbage, But for the use this has, I'm not to worried about it.

Re: Wireing a sub for out of car use

Saturday, January 05, 2008 6:47 PM

Stephen

http://www.partsexpress.com/pe/showdetl.cfm?&Partnumber=300-804 get that and set the gain a liitle low and it should be fine. if your going to use it for movies and such (stuff other than music) i would tune lower, about 25-28hz and it should be fine.

Re: Wireing a sub for out of car use

Saturday, January 05, 2008 8:17 PM

Mark

are the Dayton products any good? I have seen a few of them that are better suited for my application.

Re: Wireing a sub for out of car use

Saturday, January 05, 2008 9:39 PM

Stephen

I love dayton they have excelent SQ. I have a pair of rs-180's and seas tweets that with be replacing my cdt's

Re: Wireing a sub for out of car use

Wednesday, January 16, 2008 12:32 AM

cavie187

For the price of the conversion units -vs- the quality of the car woofer it is cheaper to go out and buy a home audio subwoofer (in most cases).

Forum Post / Reply
You must log in before you can post or reply to messages.

Start New Topic Advanced Search