im about to do my doors how much do ya guys think i need?
I'd guess 3 foot x 4 foot, so 24 square foot would do you right.
I used the dynamat extreme bulk pack which is 36sq/ft, and it did the rear deck and the whole trunk, minus about 6sq/in... 24 square foot should be plenty.
yea about 12 sqft a door will do a single layer. What product are you looking into?
3 liters of spray on per door for the outer skin
50 sq ft of mat per door for the inner
--------------------------------------------------------------
Offical dealer for the following-
SOUNDSTREAM
DB LINK
DB DRIVE
PANASONIC
GARMIN
ROSEN
SCOSCHE
XE DESIGNS
SOUNDGATE
PAC
LITEGLOW
^ thats alot.... doors probably like a vault door.
I used around 30sq feet per door, which was way overkill, but for your need and use, I would say use around 20-30.
OOh yeah... my door sags a little when its open.
Elemental Designs
Performance.Mobile.Audio.
alexl@edesignaudio.com
Warehouse Manager
i was thinking 20-25 of V1 per door and a gl of V3 for the outter door and on top of the V1
Thats more than enough....If you are going to go with V1, Ide honestly just say go with SE, and use about 15-20ft, and then 1 gallon of v3 for both outer door and plastic panels.
Elemental Designs
Performance.Mobile.Audio.
alexl@edesignaudio.com
Warehouse Manager
will 1 gallon do both outer doors and the plastic?
1 gallon does about 40-50ft.
I dont seeing it be an issue.
I used 2 gallons of V3 in my first vehicle. I did both doors, inner and outer skin, plus the panels. Then the deck lid and partial trunk.
If time is an issue, we also have the UE, 120 mil. So only 1 layer is needed. It cost more, but cuts down on install time.
Elemental Designs
Performance.Mobile.Audio.
alexl@edesignaudio.com
Warehouse Manager
Alex. Edead IS the best product out on the market. I swear I live by your stuff now. 35 sq/feet did my doors, and I could have used another 10sq/ft.
My Updated review on eDead.
-Door was ruined in a small crash, and low and behold, I could actually REUSE the stuff !. It was all still sticking 100 %, even with water all over it, and I could peel it off, and put it on my new door !. (it was really really tough tugging, but it all came off
. ANd not a single peice ripped, the product over your butyl based deadening is easy on the hands, and tougher then anything on the market.
(Compared to my brownbread, this stuff is YEARS ahead. While all my BB is peeling off, and melting brown crap all over my trunk, this stuff holds up like a champ. !
My Cav
I give up...
i'm buying a VW those people love trees, so they should love eachother too... "Andy"
brown bread is good stuff thats what i have in my trunk, but its an older product. it used to be the best out there but liek i said time's change and new stuff comed out
