Good bye led load resistors - Audio & Electronics Forum

Forum Post / Reply
You must log in before you can post or reply to messages.
Good bye led load resistors
Wednesday, January 24, 2007 6:05 AM
the five pin flasher works on the 98 cav for running leds WITHOUT loads

Grote p/n 44090

Re: Good bye led load resistors
Wednesday, January 24, 2007 6:56 AM
you do know the resistor is to limit voltage right? Im not sure how something set up for 12 volts (flasher) isnt cooking 1 volt led.s
Re: Good bye led load resistors
Wednesday, January 24, 2007 8:50 AM
If you knew what I was talking about you wouldn 't have made that post

Those are the load resistors that make the flasher work correctly not the current limiting/ voltage drop resistors

I have an electronic engineering degree
Re: Good bye led load resistors
Wednesday, January 24, 2007 9:33 AM
Quote:

Those are the load resistors that make the flasher work correctly not the current limiting/ voltage drop resistors


Winner

I'll back that.

Thanks for the P/N, there's a post buried in this section that has the 5-pin discussion









Re: Good bye led load resistors
Wednesday, January 24, 2007 10:23 AM
Mind showing a wiring diagram on how to wire these in?



Disclaimer: Dey see me Trollin' Dey hatin' for trollin dey trying to catch me ridin dirty.

Re: Good bye led load resistors
Wednesday, January 24, 2007 10:59 AM
Load resistors are easy to wire... one wire goes to the turn sig positive, the other to the turn sig ground (in parallel with the bulb).

I can post a diagram if you need it when I get home from work.

The flasher is a direct replacement to the stock one.









Re: Good bye led load resistors
Wednesday, January 24, 2007 7:19 PM
Very bad paint wiring diagram (ignore the blue line, that's the park light positive)













Re: Good bye led load resistors
Thursday, January 25, 2007 8:35 AM
Kardain wrote:
Quote:

Those are the load resistors that make the flasher work correctly not the current limiting/ voltage drop resistors


Winner

I'll back that.

Thanks for the P/N, there's a post buried in this section that has the 5-pin discussion



pwnd


deleted
Re: Good bye led load resistors
Monday, February 12, 2007 1:06 PM
i hate to sound new... but how many of the above mentioned flashers do our cars use?



Edited 1 time(s). Last edited Monday, February 12, 2007 1:07 PM


car audio noob since 1984.
Re: Good bye led load resistors
Monday, February 12, 2007 4:27 PM
Brenden Griswold wrote:
Kardain wrote:
Quote:

Those are the load resistors that make the flasher work correctly not the current limiting/ voltage drop resistors


Winner

I'll back that.

Thanks for the P/N, there's a post buried in this section that has the 5-pin discussion



pwnd

Lame.



Mike Roth
Re: Good bye led load resistors
Wednesday, February 14, 2007 1:44 PM
i just ordered my grote flasher. only place i could find one was midway auto supply online.



car audio noob since 1984.

Forum Post / Reply
You must log in before you can post or reply to messages.

 

Start New Topic Advanced Search