Hi Guys
I just want to know how hard is it to make your engine wire harness for a 3400?
From a 4cyl to a 6cyl?


Opening Soon Kustom J's

id imagine pretty tough, i mean it depends on what you have to start from.....do you have the computer, if not, then its pretty well impossible, if you do, then it will be tough but doable, if your real good with wiring


You'll never touch God's hand
You'll never taste God's breath
Because you'll never see the second coming
Life's too short to be focused on insanity
I've seen the ways of God
I'll take the devil any day
Hail Satan

(slayer, skeleton christ, 2006)

you will need the plugs for the ends


._____________________________.
Causa latet vis est notissima

DIY Clear 03+ Headlights

where can i get the plugs at?


Opening Soon Kustom J's

junkyard...but in that case you'd just take the whole harness, the plugs arent available by themselves...

if your really really good, what you could do is get the wiring diagrams and solder wires onto the pins on the computer/accessory. this would be very difficult, not weather proof, and be extermely time consuming...its basically not worth it, your better off buying a 3400 wiring harness either from a junkyard or dealership


You'll never touch God's hand
You'll never taste God's breath
Because you'll never see the second coming
Life's too short to be focused on insanity
I've seen the ways of God
I'll take the devil any day
Hail Satan

(slayer, skeleton christ, 2006)