Hey I searched on here and I used the search button and all I found was people being ridiculed about how to get that cover off to get to the 6x9's, but no one says how. So can someone please tell me how I dont wanna break anything or crack that cover, I just brought my z 24 and the interior is nice and i'm tryin to keep it that way.

Lower the back seat, and remove the 4 clips that hold the plastic trim pieces to the rear dash.
Next, remove the 2 plastic trim pieces. To do this, pull them slightly toward you, and angle them toward the ground. The small clips that hold them in will pop out of place.
Pull the rear seat belts through the slots in the back deck, and then pull the slots inward a bit. This will allow the piece of rear deck that is under the sides to come free.
Now just start pulling, and jiggling it a bit. You may also need to bend the centre of the dash up slightly, being careful not to crease it. It will eventually slide out.
If you are trying to remove the rear speakers, simply push in the little clips that are facing you. You will need to disconnect the speaker wire connection. The factory speakers are held in by 4 screws. Remove those and the factory speakers will pop right out. The Rear Speakers Are 6X9's, but you can either make or buy adapters so you can use a component speaker system.



courtersy of teamforwardmotion.com





GO PATS!!!