i planning on tearing my stock deck out which is a tape deck and want to replace with sony explode dont laugh just want a cd player nothing fancy. i seen some harness that might fit from wall mart and i seen a dash kit there too. if all else fails i will just hard wire.

but how do u get the old one out? i dont have a manual. and is there anything else i should buy?

thanks for any help
Nick

Take the plastic trim pice's off each side of the dash theres 1 screw on each side there 7mm i think,then open the glove box and there should be three in there then lift the dash pad off. then theres 3-4 screws for the trim around the radio on top just pull it after that. then i think the radio just pops out. buy the radio thing that go's around the radio and then buy the harness its easy to install just match up the wires. *i am a newbi at installing radios i did it in 20mins.

thanks man i'll try it tomorow

If it's the Scosche adaptor kit, as long as you get the right one, its a matter of matching color to color on the deck, then plug into the stock harness. I did the same thing, 5 minutes to attach splices, 30 min to install. (beer break).