cyklone wrote:How To: Disable Daytime Running Lights (DRL) on 2000-2005 J-Body Vehicles
2. There are 2 Blue plugs and 1 smaller Purple plug plugged into the BCM. Unplug the middle one by pulling back the blue tab. It will slide right out.
IT DOESNT SLIDE RIGHT OUT
any tips lol? or can i just cut it while its plugged in?
lift on the tab and pull???? i pulled mine like 5 times that way, just pull up on the tab and pull that sucker out of there
You'll never touch God's hand
You'll never taste God's breath
Because you'll never see the second coming
Life's too short to be focused on insanity
I've seen the ways of God
I'll take the devil any day
Hail Satan
(slayer, skeleton christ, 2006)
Pop the BCM out of the plastic holder by pushing apart the two plastic tabs on either side.. then you can pull the BCM out more and get a good grip on it.
<a href="http://www.lenkorules.com/"><img src="http://s93165229.onlinehome.us/images/misc/redsig.jpg"></a>
you can just cut it without removing it but....i had an easy time getting it out
are you sure i will have no problems cutting it while its plugged in?
nah, jus tbe sure the car is off...................its probably better this way...cause i had to reset my radio clock when i did it
I did this just the other day. Just simply take out the second pin connector. Besure not to cut the wire to short so you can ground it in a good spot. If you do cut it short soder (sp?) a longer piece to get it grounded.
yea thats not my problem
i cant get the damn clip out, i swear its glued.....
im asking if i can cut it while its connected
Yes you can, just make sure you have the right wire.
You're reading my line-break, you are a loser.
why disconnect drl
Sinister Ambitions
when your girl is getting on your last nerve f*#k her dont fight her
the only blueish one from the middle clip lol
