im not tryin to be an A$$ or get yelled at by people but so far on my boost project information has been very misinformed. i went to install my Safc-2 and the ECU is in the front of the engine under the passanger side bumper. idn if its different for other cars but my 99 was there. the harness doesnt fit i need to have CUSTOM extensions made to get this to fit..AEROMOTIVE AFRP's do not fit unless they are customized which i was told to use....neone else run into these problems?


speed kills, drive slow, drive a honda

You are what you Drive!

srry i wasnt paying attention if this thread could be moved to electronics. thanx


speed kills, drive slow, drive a honda

You are what you Drive!

Its only like a 6 foot harness. Extending the wires isn't THAT bad of a job, worst part is finding so many different colored wires in the stores. I ended up having to run one at a time inside the car so I made sure they connected to the right wires. After that I got some of that wire loom plastic cover stuff. If you look around in my engine bay you'd never pick out where the harness is.





4cyltuner.com - Information Source For 4 Cylinder Tuners
Buy stuff from CarCustoms Ebay! Won't be disappointed!