alright i m hoping to finish the engine by the first of the year the machine shop is just about done with all the mods so here it is :
engine is a 99 2200
with volenia 30 over forged pistons 9:1 ,eagle h-beam rods ,cleavite main,rod,cam bearings ,all new internal parts,block is deck, honed,align bored , lightened and polished crank. the head has been p/p ,s/s valves,crane gold series roller rockers , crane p-rods, shaved 20ths.
the trans is a 3spd auto with a 2800 stall yank converter,redline clutches, and a shift kit . no axles yet.
ignition:
msd dis 2 with interface blocks and coil packs . magnecor wires and tr6 plugs
fuel:
walbro 255 intank pump,fpr switch,aeromotive adjustable fpr rc 195cc inj.
brakes have been upgrade also.
i was going to turbo charge the car but ran low on money and i need to finish this car so im selling all my turbo stuff to finish then im buying a nx or nos direct port kit and hope to run a 125-150 shot on the car. hopeing for 13"s ?
13's or blowning it. one way or the other!
im building my 2.2 ohv up and im going the same route. hoping 125 DP with all forged and the DIS 2
http://www.cardomain.com/ride/2090440
James I'm just curious...if you're staying all motor with nitrous, why not up the compression?
www.kronosperformance.com / 732-742-8837
Quote:
i was going to turbo charge the car but ran low on money
I guess that's why you stayed 9:1 comp then...lol I didn't read the whole post, silly me.
www.kronosperformance.com / 732-742-8837
yea 9:1 is still good if ya ask me
< im thinking of keeping the stock compression as well or mabe a bump to 9:5:1
thanks for complements. i was looking at one of nx progressibe controllers what do you all think about those ??
13's or blowning it. one way or the other!
im thining of a direct port setup
hey what do you think about this ive got one of those worthless t/b spacers . so i was thinking about drilling it on one or both sides and threading in foggers . on the same thinking as the v8's plate system.
13's or blowning it. one way or the other!
i would say drill in one side for one nozle would be good!
