I was going to go with a used Zex kit off of ebay, but I did some research and found out about Nitrous Express's Mainline kits. I ordered one up and cant wait to install it!
Any tips or anything? I have a set of NGK TR6's sitting here and once the kit comes in I will slap them in.
2006 Cobalt SS I/H/E ZZP S2 HPT 2.8/60's Etc...13.8@105(I need to learn how to launch)
I would add that I have a WOT switch I will use instead of that push button crap. But for the price I got a deal!
2006 Cobalt SS I/H/E ZZP S2 HPT 2.8/60's Etc...13.8@105(I need to learn how to launch)
sweet. what shot are you going for
Im a Xbox 360 fanboy...and damn proud of it!!
50 shot. The kit itself is designed for at most I think 70.
2006 Cobalt SS I/H/E ZZP S2 HPT 2.8/60's Etc...13.8@105(I need to learn how to launch)
Hey chris how come your never on im anymore...
Anyways I just got my wideband today and figured you might want to tune your kit it after you get it installed. Let me know.
Sup Tom, I had to reformat. I never got around to dl'ing it again. I got it back now. Hope to see you on there. Got a different exhaust, valve cover and wider tires on it now. Plus the nitrous soon. You got a wideband? Hmm. We outta meet up one day.
Cya
Chris
2006 Cobalt SS I/H/E ZZP S2 HPT 2.8/60's Etc...13.8@105(I need to learn how to launch)
id use a normal switch...hidden amongest your console... and a WOT switch...AND a rpm window switch
Ran into a delay. The Mainline kit comes as barebones as you could get. For the fuel line that include a brass t and a length of rubber hosing.
WTF.
So I am obviously not going to use that. Finally found the info to order the parts I need.
A 1/8 NPT to -4 fitting and a -4 line.
A must for any person using this kit.
Now I have to figure out how to mount the solenoids. They have NO mounting tabs. And they are square.
2006 Cobalt SS I/H/E ZZP S2 HPT 2.8/60's Etc...13.8@105(I need to learn how to launch)
Chris Dixon wrote:Ran into a delay. The Mainline kit comes as barebones as you could get. For the fuel line that include a brass t and a length of rubber hosing.
WTF.
So I am obviously not going to use that. Finally found the info to order the parts I need.
A 1/8 NPT to -4 fitting and a -4 line.
A must for any person using this kit.
Now I have to figure out how to mount the solenoids. They have NO mounting tabs. And they are square.
Sounds cheesy but worse things have been done by automakers themself. extend your lines and super glue or rubber cement them to the firewall. Works well. Or if you wanna keep them hidden on the fender well.
if the solenoids are square you can get thin sheet metal and just make a U shaped bracket _|-|_ <----something to that affect, then drill holes for screws and you should be set.
-john
