My car runs fine @ WOT but if i hold the throttle in a steady position the revs will drop and then bounce back up and drop again then the car will die, anyone else have this problem? here's a vid of what im talkin about:
http://www.youtube.com/v/5EtjEhKMy54
1991 Skyline GTR
1996 Sunfire
![](http://i41.photobucket.com/albums/e280/MikeRWK/R32%20GTR/SDC10694-1.jpg)
My vert had a similar problem, in my case it was a bad idle air control valve.
this is the second tps i've tried and that isnt the problem, i had the iac out and it moves in and out but i'll try another one.
1991 Skyline GTR
1996 Sunfire
![](http://i41.photobucket.com/albums/e280/MikeRWK/R32%20GTR/SDC10694-1.jpg)
check the rubber gasket arount the map sensor
checked that and tested the sensor its good, the iac motor moved kinda slow and somertimes when i put the clutch in the car will hold the revs so i think its iac
1991 Skyline GTR
1996 Sunfire
![](http://i41.photobucket.com/albums/e280/MikeRWK/R32%20GTR/SDC10694-1.jpg)
Since the computer uses the MAP to determine engine load I would lean towards it being the MAP sensor. However, a bad IAC can sometimes cause you to throw a code for a MAP sensor. So if you suspect trouble with the IAC, I would say there.
i find it amusing that SHOoff has nothing better to do but follow me around & be an unhelpful dick in even cross-forum. - Jon Mick
the iac is sticking sometimes and i have a leaky injector.
1991 Skyline GTR
1996 Sunfire
![](http://i41.photobucket.com/albums/e280/MikeRWK/R32%20GTR/SDC10694-1.jpg)
Fixed both and car runs mint now, minus bent control arm.
1991 Skyline GTR
1996 Sunfire
![](http://i41.photobucket.com/albums/e280/MikeRWK/R32%20GTR/SDC10694-1.jpg)