I have the convertible cavy bar btw:
Anyone have any creative ways of doing this? I was looking this morning and the computer has to be moved and the one picture I found had it zip tied to the strut bar lol. Also how hard is it to put a bolt threw the hole in the center of the bar to attach it to the fire wall? I know it is not hard to drill the hole, but I guess what I am asking is how hard is it to put a nut on the other side of the firewall? I am not trying to rip the dash apart tonight!
move the computer into the cab and put it under the heater control by the shifter.
Or if your too lazy like me, just notch the PCM bracket to fit around the strut bar.
M62, 42's, ZZP 3", ZZP S3 H/E
214whp 190wtq
slvrblit wrote:Or if your too lazy like me, just notch the PCM bracket to fit around the strut bar.
I like this idea better than moving it inside the car. I still have to see how it looks and if it will fit. Worse comes to worse I can screw it to the firewall.
I just adjusted the bracket and only used 1 bolt to secure it at an angle on my dads car when I installed his bar.
or relocate it to under the wiper cowl. i just did it and it's a little bit of a pain in the ass but not too bad. there's a thread in p+m forum on the first or second page right now that explains how to do it pretty easily
How would you move it into the dash?
nay nay wrote:How would you move it into the dash?
its very easy all you have to do is unplug the ecu cut the zip ties so the wire is loose and shove it through the rhino's ass plug it in and hide it in the desired area...
oh...awesome. It doesn't effect anything does it?
