Installing Eibach front sway bar? (upside down?) - Suspension and Brake Forum

Forum Post / Reply
You must log in before you can post or reply to messages.
Installing Eibach front sway bar? (upside down?)
Sunday, June 08, 2008 3:38 PM
Question: On the end of the sway bar where the bushings go through, should this be pointing
up or down?? (1 1/2" off the end) The reason I ask is because the axles are real close too the
sway bar. I did a search And I cant really tell from the pictures I seen. Thanks

Re: Installing Eibach front sway bar? (upside down?)
Sunday, June 08, 2008 3:43 PM




Re: Installing Eibach front sway bar? (upside down?)
Sunday, June 08, 2008 3:44 PM
http://www.s120895520.onlinehome.us/EibachSwayBar.jpg

may be easier to just click the link to the pic then zoom



Re: Installing Eibach front sway bar? (upside down?)
Sunday, June 08, 2008 5:45 PM
thanks darkstars
Re: Installing Eibach front sway bar? (upside down?)
Sunday, June 08, 2008 6:37 PM
I just went out in my garage and I looked at the bar I couldnt read the Eibach from the (top side)engine view. So I put it up on jack stands and I layed under the car and I could read Eibach from the the underside. So my question is if I flipped the sway bar over it will still be on the back side but it will read backwards. I know frosure I didnt get the front and rear mixed up cause there marked F and R. Is the Eibach stamped in the same spot everytime? So question do the tips of the bar point up or down and if eibach reads regular or backwards when looking at it from under the car. thanks
Re: Installing Eibach front sway bar? (upside down?)
Tuesday, June 10, 2008 5:08 PM
btt
Forum Post / Reply
You must log in before you can post or reply to messages.

 

Start New Topic Advanced Search