I just replaced the rear wheel cylinders on my 00 Z24. The problem is that the driver side is leaking where the brake hard line goes into the cylinder. I tried tightening it, taking it off and make sure nothing is in there and so on. I figure I should just replace the hard line from the cylinder to just over the axle. Anyone have any suggestions on how to stop the leak or where I can find these lines already bent?

NAPA and the like usually stock ready made up rigid lines, take in the old line with fittings (if you can).

I am not sure which threads are used on your model, I know ours stocks American and Metric.


Alont

I grab a set from the wreckers every time I do rear brake work.... find a low mileage 05 or 04 car, grab those...

I'm about to replace my rears with SS lines if you are interested.



FU Tuning