I am in the process of installing my front bar. Got it for a good price but there was no instructions. I have searched here and on the net but to no avail.. Simple question is do the ends of the bar point up or down. Any pics would help. The bar is in position with the tips up but it seems that it will contact the drive axle when all is tightened up. Any advice is appreciated.

http://i79.photobucket.com/albums/j130/mykeln/mysig.jpg

up

Yeah they go up...

Okay the bar is installed with tips up. Looks like I will have some contact with the boot clamp on the CV joint. Should I get out the sawzall or grinder or did I do some thing wrong?

http://i79.photobucket.com/albums/j130/mykeln/mysig.jpg

I went out to the garage and snapped a few pics so it would help better than words.


Drivers side no problem




Passengers side a little tight




Grind Cut or re install

http://i79.photobucket.com/albums/j130/mykeln/mysig.jpg

If I am not mistaken, that is the rear sway bar (not the front one).....check out this thread....
http://www.j-body.org/forums/read.php?f=3&i=118573&t=118531#118573

if you don't want to read through the thread, it takes you to this site:
www.wildweasel.ca

If you don't want to click aroound and look for the right link, the site will take you here:
http://www.wildweasel.ca/j-body/HowTo/EibachRearSwaybar.asp

Hope this is helpful. Enjoy!



Click on my sig to check out my CarDomain site. Enjoy!

Swap the end links form front to rear and rear to front. The end links come packaged wrong, you will have interference issues untill you swap them. Seen this many many many times already, even on my own car and always with the Eibach pair.

if u wanna get rid of the front sway bar.....let me know...lol...