hey everyone,

it's been a week now since i changed my brakes with powerslot disc and hawk pads, then i noticed that my driver side is not seated properly because the disc is rough and i can see lines of uneven fading, compared to my passenger side it's smooth and clean.

i didnt hear any abnormal noises since i installed this brakes. i have'nt done any sudden or abrupt braking at all.

Could this an indication of a bad caliper pistons? Any ideas wat could be causing this?



thanks in advance guys,
Al

Did u break them in??

-Seth

Did you grease the slide pins?

yes id did break them in. Me & my bro. also bleed the calipers and put ac delco dot 3 fluid.

I used anti-seize for the slide pins.


thanks again

pics?

if you did not sand the hub down where the disc mounts then you may have some rust under the disc . this will cause the disc to have what is called runout and will cause the disc to wear uneven .......

hope you get it worked out .. good luck

I disassembled my brakes agian today found that the lower slider pin isn't sliding freely compared to the upper one, the grease doesnt seem to stay inside the rubber boot. I cleaned it & tried putting some grease again, I hope this is going to work out fine. But if it doesnt, i'm thinking of getting a new caliper kit.

Anybody know how much is a new caliper Cdn $$ ?