Eco
ICM
Coil assembly
Coil to plug connectors (boots) (8 total)
All are brand new, never used.
2.4
ICM (used, 38500 miles)
New intake manifold gasket
Main bearings (new Federal Mogul .25mm undersize)
Rod bearings (new Federal Mogul standard size)
2.3
ICM (mileage unknown)
E-Manage with software (used for a short time on my car a few years back)
2000-02 Z wheels (2 decent tires, 2 need replaced) $250
Motegi RT5's 17" wheels painted black ( need tires) $300
2 Alternators (mileage unknown, worked when removed) $25 ea
A/C compressor (about 65K miles, removed due to A/C delete) $50
2 stock intake manifolds $20
Stock air box $20
Non sunroof headliner (neutral) $30
2000 coupe dash carrier (part that has a cracking issue) $100
Alky Control alcohol system $400
97 LD9 block (mileage unknown, looks ok, had a spun #3 rod bearing) $75
If you are interested in anything I have listed or something not listed (I have lots of parts for the J cars) make an offer or send a message with what you are looking for. I am also open to offers on the parts that do have a price listed.
Anyone?
I need to fund repairing my car.
if you can give me a good deal on the rims w/shipping i might be able to get them.
UPDATED CARDOMAIN
Cardomain page
I rather suspect it would cost more to ship than it would be worth. Just the bare stock wheels are about 22 lbs each, add in the weight of the tires. I dont even know how much the Motegis weigh.
were in mich are you located and some pics of the wheels would be nice
Unfortunately my camera has gone missing or I would have had pics up by now.
I live in Warren, suburb of Detroit.
I have this pic from when they were on the previous owners car Cadwz24) They still look the same except tires need replaced.
Edited 1 time(s). Last edited Sunday, November 25, 2007 1:18 PM
do u have ne more information on the alky injection kit???
Alky Control progressive control kit that I purchased in 05. I used it with the S/C but was unable to use it with the turbo. The pump and controller were replaced this past spring and used for about 1K miles before the system was removed. I used my stock washer tank (modified of course) for the alky resevior. There is a low level sensor built into the tank. Has a m5?? nozzle and filter. Been a while since I looked at it so I cant recall much more about it.
thanks^^^ what all is included in the kit? and $400?
Pump, controller, nozzle, filter, lines, tank with sensor, Bracket for mounting pump. Just the replacement pump and upgraded controller cost me $500 in the spring. This is one of the few items that I am firm on the price. Would have to dig it all up but should all be in a box in my storage unit.
These are braided lines, not the cheap plastic ones, progressive controller that the user can set the turn on and gain, barely used pump (surflow). Honestly if $400 is to much for you I will just keep it around and find something to use it for.
well i wont have money till after Christmas (shopping already killed my wallet)
but i should be able to after
i live damn close too
in romeo at 34 mile and van dyke
so if they are still for sale when that come around ill grab them
and if not ill grab the 02 z wheels then
well just let me know. Im sure they will still be around. As you can see there isnt a whole lot of interest in this stuff.
can you see how much the motegis weigh. i don't need the tires.
UPDATED CARDOMAIN
Cardomain page
I no longer have acess to a tire machine and Im not going to pay a company to remove the tires. I want to say they were 17 Lbs each.
If you want this information for a shipping quote, I must state again the cost and hassel would be more than i am willing to deal with.
Also have a 2.4L crank with 2.3 oil pump drive on it and set of Eagle rods. Both have about 16K miles on them. Same engine build. Make an offer.
00-02 Z wheels spoken for.
how much are you askin for them?
the rods? Make an offer. Figure shipping would be around $30-40.
00-02 Z wheels available again.
