about freakin time! lol nice job
1997 Cavalier Z24 - 16.3 in 1320 and falling...
nice greg looks like a nice clean install.
NEW CAR SHOW www.loweredintentions.ca
Thanks guys now it just needs a saftey and the AC charged and i can go get it plated
Nice job.
~Claps~
Also where you get your floor lift?
PRND321 Till I DIE
Old Motor: 160whp & 152ft/lbs, 1/4 Mile 15.4 @88.2
M45 + LD9 + 4T40-E, GO GO GO
ITs from a company in mississauga ontario it was 1300plus tax. my dad is getting the phone number when he finds it i will post it
GM Charger time
My Cav
I give up...
i'm buying a VW those people love trees, so they should love eachother too... "Andy"
Just Ordered my Air Intake, and pick the lowering Springs up soon
I will be driving it Thursday though went for saftey today and my dads going to drive it for a day
Nice work Greg
Did you go with a AEM intake?
Looking forward to the lift info
Nope just the Cheap Cosmoracing one for the Ecotec i don't need anything fancy
or crazy expensive just a DD probably going to order there short shifter aswell
watch the install on the intake...the instructions for the rubber elbow are backwards of what it says,,,you will easily see this as the elbow will not have clearance if you put it on the way the instructions tell you to
lol buddy i don't think greg needs instructions to install an intake if he can do an engine swap
looks great....almost did one before i built my motor instead...lol.. jayo's taking a beating in both forums..
"If you have no clue what's going on... STFU!"
Just ordered my Prothane Control arm Bushings
and Lowering springs. then i need a header
Works great intalled the intake, fixed the exhaust leak, and put in the new splash panels for the bumper.
then drove it to Michigan yesterday no issures thing is AMAZING on fuel though
