i know there are a few post about this and i tried to hook it up according to one of them but the wiring diagram was not right and i still cant figure this out.
i am running the neon coil swap on my 02 z24 and stock ignition module.
if anyone has the wiring diagram, or just know how to hook it up please explain.
i had it hooked up and working on my buddies srt-4 but i had the right wiring diagram for that.
anything helps.

These are the vehicle specific instruction I received from Jon @ N2MB


The specific wires for your car as follows:

WOT Box YELLOW wire would connect to one of the fuel injector negative wires, for example with injector #1, it would be a BLACK wire at the injector or a BLACK wire at pin 51 of the PCM.

WOT Box BLUE wire connects to Throttle position sensor pin #C, DARK BLUE or pin #31 at the ECU (also DARK BLUE)

WOT Box GREEN wire connects to cruise control clutch switch pin #B, BROWN / WHITE or pin #D at the cruise control module ( also BROWN / WHITE)

Now, for the WOT Box RED / BLACK, it looks like you only have one ignition coil power wire, so you will just cut the PINK wire at the coil or at the ignition module fuse. You will be left with two halves of the wire. Connect the coil side of the PINK wire to the WOT Box BLACK wire of the RED / BLACK pair. Connect the fuse side of the PINK wire to the WOT Box RED of the RED / BLACK pair. That way the power is going through the WOT Box, like an inline switch.




I haven't installed mine yet....but this is how I plan on doing it. Did you use these exact instructions??

Check this thread for more info Click Me!


Or call Jon @ N2MB for help if your still having trouble.