02 Sensor Simulator - Performance Forum

Forum Post / Reply
You must log in before you can post or reply to messages.
02 Sensor Simulator
Friday, May 14, 2010 9:43 AM
So about 7 years ago I bought an 02 Sensor Simulator back when I had my Z24. Never used it and bought my 03 and haven't paid any attention since.

I've been throwing some codes since I did my exhaust and that popped into my mind. Does anyone know if that will still work with an eco? Thought since I have it I might as well check, its been so long since I paid any attention.





Re: 02 Sensor Simulator
Friday, May 14, 2010 9:46 AM
I dont think it will work.
Use HPT and delete the code
Re: 02 Sensor Simulator
Friday, May 14, 2010 9:56 AM
Should still work all O2 sensors toggle the same in the post cat its just checking efficiency of your cat


Erik Packard
Re: 02 Sensor Simulator
Friday, May 14, 2010 10:20 AM
Ricozero wrote:Should still work all O2 sensors toggle the same in the post cat its just checking efficiency of your cat


Thats what I thought but not sure. I don't think I want to spend all that on HP Tuners when I would use it for maybe 3 things.




Re: 02 Sensor Simulator
Friday, May 14, 2010 2:05 PM
Do the manual O2 sim.



FU Tuning



Re: 02 Sensor Simulator
Friday, May 14, 2010 2:42 PM
Too Whiney wrote:Do the manual O2 sim.


Info on this? your not talking about taking it off and mounting it near the heat shield are you?




Re: 02 Sensor Simulator
Friday, May 14, 2010 6:44 PM
no go to you part store and get two Spark Plug anti-foulers.. they cost like 5 bucks together if that....

drill one out with a 1/2" bit, thread the two together, and install between the o2 and the bung.



Re: 02 Sensor Simulator
Friday, May 14, 2010 9:25 PM
It should work fine unless the sim is just fried.




I <3 JGM
I think bigfoot is blurry,
that's the problem. It's not the photographer's fault. Bigfoot is blurry. And that's extra
scary to me. There's a large, out-of-focus monster, roaming the countryside.
"Run! He's fuzzy!" "Get outta here!"

In Loving Memory of Phil Martin December 14 2005

Re: 02 Sensor Simulator
Sunday, May 16, 2010 4:42 AM
i did the anti-fouler and that worked well for a while. when my cat went i had to punch it out, then my cel came on. so i filled the bottom spacer hole with jb weld and no cel for the last three m onths
Re: 02 Sensor Simulator
Sunday, May 16, 2010 12:03 PM
Funny thing is I just cleared out the codes and drove 75 miles stop and go and haven't thrown a code. It would be great if it just works out now, the strange thing is when I read the code it said it was running lean. When I went to start my car after doing some of the work the ECU was barley unplugged and I had no fuel pump or pressure. I checked the ECU snapped it all the way down and the car fired right up also throwing that code. I think it may have been related to that start up.





Forum Post / Reply
You must log in before you can post or reply to messages.

 

Start New Topic Advanced Search