I am going to be installing a fuel pressure gauge, it comes with a 1/8npt sending unit.
I think the easiest way to hook it up is to the schrader valve on the fuel line. Does anyone know for sure what the thread size is on the schrader valve? Is is 4an? Is it possable to connect the sending unit up to the inside of the schrader vavle? If so what is the thread size of that.
Thanks





]:-> 287 TimeSlips In Hand. Car Still Runs Strong... 3 Differentials Later ]:->

Just get the Aeromotive AFPR. It has a nice gauge port built right into it.



I used to race cars, now I race myself.
5K PB: 24:50
10K PB: 54:26

Naw.. I dont want to install a FPR. No point right now.



]:-> 287 TimeSlips In Hand. Car Still Runs Strong... 3 Differentials Later ]:->

Schnupper wrote:Does anyone know for sure what the thread size is on the schrader valve? Is is 4an? Is it possable to connect the sending unit up to the inside of the schrader vavle? If so what is the thread size of that.
Thanks

1/4", IIRC.


Go beyond the "bolt-on".

K I will try that Its easer to find a 1/4npt to 1/8npt then finding a 4an to 1/8npt. LOL

Anyone else?



]:-> 287 TimeSlips In Hand. Car Still Runs Strong... 3 Differentials Later ]:->