Ordering the clevite trimetal 77 bearings, if i use eagle forged esp rods are the bearing still the same? Yes right? that doesn't count as a oversized rod does it? its for a 95 2.2 pushrod motor.
thanks for the help
jason
The rod's bearing dimensions don't change between stock or aftermarket rods, as long as that rod was built for the same motor. If by oversized, you are referring to the numbers after the part number (CB-745P STD,1,2,10,20,30,40,C60), that would be undersized for cranks that have been turned down or polished. These undersizes are in one thousandths of an inch. A polished crank would only require the 1 or 2, while a turned crank would require a 10, 20, etc...
Forum Post / Reply
You must log in before you can post or reply to messages.
