I dont know what eco this is for I cant find any more discription then that u guys have any idea? Extrude honed exhaust manifold -Pn 19131972 It's $234.50 on gm parts direct
darkblade j
GM recommends it for the LSJ motor, I think there are people that installed it on their 2.2s without any noticable gains. CHeck out the Cobalt and Ion Forums.
Check out my car....
http://members.cardomain.com/o4blackfire
Or you could just buy a header.
Semper Fi SAINT. May you rest in peace.
yea, i would just buy a header that will match up with whatever future plans you have for the motor.
Click the banner to enter the best Quad4 & Twin Cam site on the internet.
Yea but I so sick of over priced extremly low quality aftermarket parts that break don't last or need modifaction to fit the car. And if a header is like $400 plus you need to get it weilded for $100 and then it just rusts. That seems like crap to me!!!!!
darkblade j
Where thave you ever gotten a $400 header that just rusts? Seriously. My old Cavalier had a cheap $150 OBX header from eBay that was stainless steel, fit perfectly the very moment I installed it, and never gave me any problems. I didn't even break a weld on it until I rolled my car off the interstate, at which point the weld before the cat busted, and I don't think that counts as normal wear and tear. Trust me, you can get a good header for less than that stupid manifold. Extrude Honed or not, it's still a factory manifold.
Be kind to dragons, for you are crunchy and taste good with ketchup.
^ ^ ^ ^ No doubt ! $400.00 will land you a top notch ceramic coated header and they CAN'T rust. You can pich up a regular header for around $150.00 and most are ment to be staraight bolt on replacements. Sure yo may have to cut some pipe off but its designed to mate right up to the stock system in most cases. I don't know what headers your talking about.
Semper Fi SAINT. May you rest in peace.
Well I looked at one and it didn't just bolt up it needed work. Are there any that just bolt on? I have an eco are there? any cheap ones?
darkblade j
<typical jbo ahole response>
search
</typical jbo ahole response>
this topic has been covered many times.... maybe even have a look at what I've posted recently
Email sent...
Pacesetter's armor coated header runs about the same price. Install will be just about the same as installing a new manifold.
Go to eBay and search for the OBX headers. They're stainless, won't rust, cost about $150, and bolt right up to the stock exhaust. Just make sure with whatever header you get you either install motor mounts or get a flex pipe installed on the exhaust.
Be kind to dragons, for you are crunchy and taste good with ketchup.
