I have a 2.3, and I was wondering if the 2.3 HO Intake would work? If so, what do I have to do to make it work? If not, could someone explain to me why? I need all of the knowledge that I can get, and where else to get it, but from fellow J-Bodiers! Thanks.
Your dreams are rich.....Live by your dreams.....
you must have the 2.3 LO. You might wanna wait till a few of the members make comments. It's the same manifold just the bulge in the HO is slightly different than the LO.
I'm wondering what kind of gains you'd get if any.
95 Sunfire GT In Progress wrote:I have a 2.3, and I was wondering if the 2.3 HO Intake would work? If so, what do I have to do to make it work? If not, could someone explain to me why? I need all of the knowledge that I can get, and where else to get it, but from fellow J-Bodiers! Thanks.
Should be a direct boltup.
You take off the old one, you put on the Ho, you start the car and go.
Gilles
2.3 Ho
What are the pros and cons of swapping out my LO intake manifold to a HO intake manifold?
Your dreams are rich.....Live by your dreams.....
In my own opinion..... correct me if I'm wrong (and I'm sure that someone on here will) but, if you get more out of the 2.4 motor putting the HO intake on it then you would putting on the LO intake..... then the LO 2.3 "should" binafit from swapping out to the HO intake manafold. They say that the HO flows better and has larger runners then the Lo intake?
