Okay
i currently have a 2.5" catback with the 2.5" hi-flow cat...
was wondering how you all with the 2.5" pipe get a header on? the pipings are usually different sizes...
SPONSORED BY: CAVALIER EXTREME
i think most people just lifted the car up. took off the old header. put on the new one
but if you are not sure. have an exhaust shop do it for you
Im a Xbox 360 fanboy...and damn proud of it!!
its a "flange" ..its gets welded on the downpipe and bolts up to the end of the header....
did i explain that right?
Go ahead and see just how powerless you are. .... ROGER THAT!
yeh but i mean the downpipe is usually around 2.25" and my h-flow cat is 2.5" how would they bolt up?
How do u all having a 2.5" catback run a header?
SPONSORED BY: CAVALIER EXTREME
you'd have to get the pipe flared to fit the new size, it can be stretched .25" max, shops have the equipment to do this
14.82 @ 97 mph
What the other Jason said. Also, most shops should carry adapters or fittings to do inline size changes. It's not a big deal, any shop can deal with it.
I would say something about 2.5" being too big, but it's useless at this point.
