this questions is about the removal of my AC


ok so i have almost all of it out... but i have a few questions...the black solenoid lookin pump type thingy thats screwed onto the firewall....i remove that right? and also there are 2 aluminum lines running to the firewall...are they both for the AC? can i just disconnect them at the firewall and all will be fine?

yup!

and oh... in your sig graphic... i think you need a front end alignment lol




I was a retard, and now I'm permanently banned.

haha thanks ill look into that alignment and thanks for the help




also....can i just clip the wires at the firewall and cap them off ? or do i have to completely take it out under the dashand everything

and should u cap off those aluminum lines? or will it be safe to just leave em be

The Other Matt wrote:haha thanks ill look into that alignment and thanks for the help




also....can i just clip the wires at the firewall and cap them off ? or do i have to completely take it out under the dashand everything

if you just cap them off you shouldn't have any problems...




I was a retard, and now I'm permanently banned.

ahhh good knews lol

now that i finally have my AC taken out i can relocate my Cruise Control box to the left side of the firewall where that black solenoid cylinder pump lookin thingy for the AC was and install my rksport 4-2-1 header

Are you using the pulley, leaving the compressor there, or using a smaller belt?





4cyltuner.com - Information Source For 4 Cylinder Tuners
Buy stuff from CarCustoms Ebay! Won't be disappointed!

for now im leaving the compressor there.... but ill be putting a smaller belt on soon