i just got an autometer 5" tach and i was wondering what to hook it up to. i don't have a tach in my cluster and my car is manual. any help is appreciated.
Screw you guys, I'm goin' home
where can i get a tach adapter???
Screw you guys, I'm goin' home
rksport, gravantuning, Aplusperformance, Jim at gravana has them listed right on his page and so does RKsport. Ask jayson and he can prolly help you out aswell. I got pic's someone threw up not too long ago of the autometer adaptor.
don't you just run a wire to one side of your coil?
A little more than that. YOu need the adaptor which take the signal from the pink wire goes into the adaptor where it goes to your tach and completes the circut back to the pink wire. If you look at autometer site it shows your a diagram on how to wire it in. From the pictures i have and the info i read, it seems like an hr at most job to make it look really clean.
OK but here's another thought. I just swapped my auto cluster to a 5spd cluster with a tach and it works fine (except for the highbeam light is on when the highbeams are off and off when they are on)... couldn't I just tap into the signal going to the cluster?
nevermind, read in another thread that it's only "half a signal".. what the heck does THAT mean?
PS: I'm working with a 95 Cav here.
Ooooh, didn't realize there were two coils.
get the adapter from carbon by design its like $12 and its fast shipping!and and they will give you the instructions
i couldn't find anything on that website, could you post the link
get the adapter from carbon by design its like $12 and its fast shipping!and and they will give you the instructions
