ok this is again a problem i took off the modules and now i am just running headers high flow cat all the way 2 1/2 spark plug wires and warm air intake. when i took the modules off i just pulled them off i left a few connectors on but nothing to ground it out or anything and my temp gage does not work. but the question is could it be the o2 sensor or the temp sensor because it was working great for about 3 days and then it started back again jerking at about 20mph and when i stop it stops. this is getting bad. thanks to any help.

Modules? What modules are you talking about?





4cyltuner.com - Information Source For 4 Cylinder Tuners
Buy stuff from CarCustoms Ebay! Won't be disappointed!

i dont have a clue about modules

is everything grounded

my venom module and jet module

Good, keep them off...

I would connect back up whatever you disconnected to install the "modules", those things are trash.





4cyltuner.com - Information Source For 4 Cylinder Tuners
Buy stuff from CarCustoms Ebay! Won't be disappointed!

i havent un grounded anything. could it be the o2 sensor or my thermostat? since i have an aftermarket exhaust?

ahh
sell those pos

ok i get that i should sell the modules but what is wrong with my car NOW!! they havent been on my car for three days and it is still doing the same thing. at first my car ran fine but now I am all the way back at step one.

are all the wires connected properly?

YES they are. I re hooked up everything back to stock.