Hello all,
Anybody knows what the size of the crankshaft pulley bolt is for the 2.4L.
I'm still trying to figure this out. Is it metric or standard?
SoupMan
- and no, 'Soup' in SoupMan does not stand for Soup Up but for 'Soup' as in Lipton 'Soup'. -
Most of the car is metric...
Jay
One huge aluminum wing - $200
More vinyl graphics than your ride can handle - $150
Decals for products you don’t even have - $10
500lbs of Car Audio equipment in the trunk - $1500
----------------------------------------------------------------------------
Getting slaughtered by a KIA - Priceless
Actually, the lug nuts for the wheels are 3/4
But I found out that 27mm was the correct size BUT, don't be worried if you feel a little bit of loose. It feels like it's not the right size but it's close enough that it will allow you to remove it. I ended up using 1 1/16 because it's something like 1/10 mm smaller.
SoupMan
- and no, 'Soup' in SoupMan does not stand for Soup Up but for 'Soup' as in Lipton 'Soup'. -
