ok so my 96 z24 stock other than CAI and header, is sputtering and idling low and almost dying out. its getting the PO107 "MAP/BARO Sensor Low Input" should i just change out the sensor or are there some other things that could be the problem?
It ran fine a yr ago then slowly it just started getting worse and worse.
Any help is appreciated.
i checked the signal wire and im getting 4.81v. i know i should be getting 5v but should it be exactly 5v or is it give or take a bit?
The vac line to the map sensor in good shape?
yea its in great shape not dry or cracked at all.
replace the sensor first then get back to us if its still doing it.... if a new sensor doesnt cure the problem check wiring... and no it should not be at exactly 5v 4.81volts will suffice
Erik Packard
